Fire Alarm
DMP XR-Series Combination Fire installation, service & monitoring
DMP XR-Series — combination commercial fire alarm and burglary from a single American-made platform.
Products
DMP XR-Series Combination Fire products we install
- XR550 — 574-zone combination fire and burglary panel (UL 864 9th ed.)
- XR150 — 194-zone combination commercial fire and burglary panel
- 1100-Series 900 MHz two-way encrypted wireless smoke and heat detectors
- 263C / 265C addressable and wireless zone expansion
- 7800-Series LTE-M dual-SIM fire alarm communicator
- SCS-1R IP + cellular receiver at our UL-Listed central station
Installation
DMP XR-Series Combination Fire installation
- DMP XR-Series combo fire + burg deployments — UL 864 submittals, battery calcs, voltage-drop calcs, and AHJ acceptance testing coordinated in-house.
- Riser diagrams, battery calcs, and voltage drop calcs stamped for AHJ submittal
- Coordinated shop drawings integrated with sprinkler, elevator, and HVAC trades
- Panel commissioning and full point-to-point test to sequence of operation
- Acceptance test walkthrough with the AHJ on-site
Repair
DMP XR-Series Combination Fire repair & service
- Same-day dispatch for panel troubles, ground faults, and open loops
- Battery replacement, SLC device replacement, and NAC circuit repair
- Voice-EVAC amplifier and speaker circuit troubleshooting
- 5-year sensitivity testing and annual NFPA 72 inspection
Monitoring
DMP XR-Series Combination Fire monitoring
- UL 864 Listed central-station signaling over dual-path IP + LTE-M
- Priority handling for water flow, pull station, and general alarm
- AHJ dispatch, tenant call list, and runner service
- Monthly signal history and annual inspection reporting
Compatibility
Compatibility & integrations
- UL 864 9th edition COMMERCIAL FIRE listing — approved for protected-premises fire alarm service
- Combines fire and burglary in one enclosure with one keypad and one communicator
- Native LTE-M signaling — no POTS lines required
- Integrates with Entré access control and DMP video for unified life-safety and security
- Contact ID and native SIA reporting to the SCS-1R receiver
FAQ
Frequently asked
Do you install new DMP XR-Series Combination Fire systems in California?
Yes. Fireside Security is a licensed C-10 contractor and an experienced DMP XR-Series Combination Fire integrator across California. We handle design, permit submittal, installation, commissioning, and acceptance testing.
Can you take over service on an existing DMP XR-Series Combination Fire system?
Yes. We routinely take over DMP XR-Series Combination Fire systems installed by other contractors. We start with a full site survey, verify programming, replace end-of-life components, and bring documentation current.
Do you monitor DMP XR-Series Combination Fire fire alarm panels at a UL-Listed central station?
Yes. All monitoring is delivered from a UL 864 Listed central station over dual-path IP + LTE-M cellular — no dependency on copper POTS lines being retired in 2026.
Other fire alarm platforms
Ready to modernize your facility's life-safety infrastructure?
Talk to a licensed security specialist about your fire alarm, monitoring, POTS replacement, access, or video project. Same-day site surveys throughout California.