San Francisco Pillow Test (SFFC 1103.7.6.1) — 75 dBA at every pillow. Deadline passed; fines are being issued.

Get compliant →

Radionics / Bosch · Fire/Burglary

D9412G monitoring & upgrades

The Radionics D9412G came before the GV-series and is still common in larger commercial buildings.

At a glance

Panel details

Manufacturer
Radionics / Bosch
Model
D9412G
Family
G-series
Panel type
Fire/Burglary
Communicator
Built-in dialer. Network options depend on revision.
Documented formats
Modem IIeBFSKContact ID

Technical notes

What to know about the D9412G

  • Usually reports in Modem IIe. Confirm receiver support before changing anything.

Why customers call

Common reasons for a monitoring upgrade

  • Copper line retirement
  • Receiver support

Phone lines

Telephone line replacement

  • The D9412G's built-in dialer expects a phone line. When the carrier removes copper or moves the line to VoIP, signals can be delayed, partial or lost.
  • We test signals to the central station before and after the change, so you have a record that every alarm, trouble and supervisory signal arrives.
  • For fire alarm monitoring, the replacement path must meet NFPA 72 and the local fire authority's requirements. Some jurisdictions require a permit or acceptance test.

Cellular & IP

Monitoring options

  • Commonly documented formats for this model include Modem IIe, BFSK, Contact ID. The format actually in use depends on programming, firmware and any attached communicator.
  • Because this panel may use a manufacturer-specific format, we usually prefer a manufacturer-compatible cellular or network path, or reprogramming to a format the new communicator supports.
  • For fire signals, we use communicators listed for fire alarm service and dual-path (cellular plus IP) options where appropriate.

Takeover

Commercial monitoring takeover

  • We inspect the D9412G, confirm programming access and back up the existing settings where possible.
  • We move the account to Fireside's UL-Listed central station and set up your call list and dispatch instructions.
  • Every zone and trouble signal is tested end to end before we close out the job.

See fire alarm system takeover.

Fire alarm

Fire alarm monitoring

  • Alarm, supervisory and trouble signals are monitored 24/7 by a UL-Listed central station.
  • Replacement communicators are listed for fire alarm service and installed to meet NFPA 72 and local fire authority requirements.
  • We can also handle annual inspection and testing for the same system.

Learn more about commercial fire alarm monitoring.

FAQ

D9412G questions

Can Fireside monitor my Radionics / Bosch D9412G?

In most cases, yes. We check the D9412G's condition, programming access and reporting format on site, then recommend whether to keep it with a new communicator or replace it.

What happens to my D9412G when the phone line is removed?

Its built-in dialer can't reach the central station, so signals stop or become unreliable. A cellular or IP communicator restores reporting.

What format does the D9412G report in?

Commonly documented options are Modem IIe, BFSK, Contact ID. The actual format depends on programming and any attached communicator, so we confirm it on site.

Model and format information comes from manufacturer documentation and field experience. Panel revisions, firmware, programming and attached communicators change what a specific system can do, so Fireside confirms every system on site before quoting. Fire alarm monitoring changes must meet NFPA 72 and local fire authority requirements.