Radionics / Bosch · Intrusion
D4112 / D6112 monitoring & upgrades
The Radionics D4112 and D6112 are early, small command centers still found in some older buildings.
At a glance
Panel details
- Manufacturer
- Radionics / Bosch
- Model
- D4112 / D6112
- Family
- D4000 / D6000
- Panel type
- Intrusion
- Communicator
- Built-in dialer with older Radionics formats.
- Documented formats
- BFSKPulse formats
Technical notes
What to know about the D4112 / D6112
- BFSK and pulse-only reporting give very little detail. Replacement is usually the best path.
Why customers call
Common reasons for a monitoring upgrade
- Limited reporting detail
- Panel age
Phone lines
Telephone line replacement
- The D4112 / D6112's built-in dialer expects a phone line. When the carrier removes copper or moves the line to VoIP, signals can be delayed, partial or lost.
- We test signals to the central station before and after the change, so you have a record that every alarm, trouble and supervisory signal arrives.
Cellular & IP
Monitoring options
- Commonly documented formats for this model include BFSK, Pulse formats. The format actually in use depends on programming, firmware and any attached communicator.
- Because this panel may use a manufacturer-specific format, we usually prefer a manufacturer-compatible cellular or network path, or reprogramming to a format the new communicator supports.
- For intrusion, cellular with IP backup keeps alarms flowing if one path goes down.
Takeover
Commercial monitoring takeover
- We inspect the D4112 / D6112, confirm programming access and back up the existing settings where possible.
- We move the account to Fireside's UL-Listed central station and set up your call list and dispatch instructions.
- Every zone and trouble signal is tested end to end before we close out the job.
FAQ
D4112 / D6112 questions
Can Fireside monitor my Radionics / Bosch D4112 / D6112?
In most cases, yes. We check the D4112 / D6112's condition, programming access and reporting format on site, then recommend whether to keep it with a new communicator or replace it.
What happens to my D4112 / D6112 when the phone line is removed?
Its built-in dialer can't reach the central station, so signals stop or become unreliable. A cellular or IP communicator restores reporting.
What format does the D4112 / D6112 report in?
Commonly documented options are BFSK, Pulse formats. The actual format depends on programming and any attached communicator, so we confirm it on site.
Related
Other Radionics / Bosch panels
Model and format information comes from manufacturer documentation and field experience. Panel revisions, firmware, programming and attached communicators change what a specific system can do, so Fireside confirms every system on site before quoting. Fire alarm monitoring changes must meet NFPA 72 and local fire authority requirements.
